Makeshift weapons

Makeshift weapons are offensive weaponry or equipment that can be made with relatively common and low tech items. They are significantly less effective than more modern and effective Security items, but these weapons can prove to be very useful in a pinch and can surprise even the most hardy of people.

Construction

Cablecuffs

Cable cuffs are makeshift handcuffs. They are easier to break out of, and wirecutters will remove them instantly, but otherwise they still function as normal handcuffs. You need at least 15 coils.

Requires
15 x

 Click on the Cable Coil in your hand and select "Make Cable Restraints".
 Alternatively, you can hold some cable and click 'Make Cable Restraints' in the object tab.

Spear

The spear is a makeshift melee weapon which can only be held in hand or on your back. It does 10 brute when wielded with one hand, and 18 brute when wielded in both hands.

Requires
1 x , 15 x , 1x

 Make Cable Restraints from the Cable Coil.
 Use the Rods on the Cable Restraints.
 Use the Glass Shard on the Wired Rod.

Explosive Lance

The explosive lance is a weapon, which upon contact, activates the grenade attached to it. Most effective when thrown towards an enemy. A 100 Potassium/Water mix has a 1 tile gibbing radius, an effective and makeshift way of permanently taking care of a Changeling.

Requires
1 x , 15 x , 1x , 1x

 Make Cable Restraints from the Cable Coil.
 Use the Rods on the Cable Restraints.
 Use the Glass Shard on the Wired Rod.
 Attach a Grenade to the resulting Spear.

|}

Stunprod

The Stunprod is a makeshift Stun Baton which consumes much more battery life and stuns for less when used, it will keep a target down for about five seconds which is enough time to slap some cuffs on. Expect to get thrown in the brig if caught with this weapon by Security. It is possible to recharge a Stunprod after depleting its power supply, simply use a Screwdriver on the prod to remove the Power Cell and either replace it with a fresh cell or put the dead cell in a Cell Charger. Rechargers are also surprisingly compatible with Stunprods.

While the Stunprod is great for self-defence it deal poor damage to targets, best usage of the Stunprod is to subdue your target or use it to get distance between yourself and the target.

Requires
1 x , 1 x , 15 x , 1x

 Make Cable Restraints from the Cable Coil.
 Use the Rods on the Cable Restraints
 Use the Igniter on the Rods
 Use the Power Cell on the assembled rod.
 =========Alternatively=============
 Collect all components and place on a table
 Click and drag the table to your sprite
 Select "Stunprod" and wait a few seconds

Chainsaw

The Chainsaw is a glorified version of the circular saw, with extra robustness. You can even surgically replace your arms with chainsaws, if you would like your dream about the unstoppable Double Chainsaw Griffon Man to come true. They can be tablecrafted using a circular saw, a plasteel sheet, some cable coil, and a welding tool. Don't forget to turn it on!

Requires
1 x , 1x , 1x ,

Collect all components and place on a table
Click and drag the table to your sprite
Hold the welder
Select "Chainsaw" and wait a few seconds

Improvised Explosive Device (IED)

The IED is a firebomb made out of a soda can. It is weak but it can do lots of damage if used correctly, from setting fire to crew to breaking power wires. It has a random timer between 3 and 8 seconds, so use it wisely!

Requires
1 x soda can, 1 x , , 1 x

Fill the can with welding fuel
Put the can, the igniter, and the cable coil on a table
Click and drag the table onto your sprite

Flamethrower

The flamethrower creates a stream of flame that superheats the air and causes those caught in the flame to catch on fire. It has a range of about three tiles and is most effective against alien weeds and space vines; while very effective against the aforementioned two infestations, the flamer is at best a suppression weapon against human targets and at worst a suicide attack to yourself. You are better off using a Stun Prod or a Toolbox to do direct damage, however the flamethrower is great for area denial, AoE attacks, and damage done over time (both from catching on fire and the hot state that it leaves the surrounding air in). When using a flamethrower either wear a Firesuit to protect you against the high heat or move back as soon as you fire the weapon.

May simply cause masses of plasma to be spewed everywhere if the pressure settings are too high.

Requires
1 x , , 1 x , 1 x , 1 x

Screwdriver the Welder
Add Rods to the Welder to create the Flamethrower
Screwdriver the Igniter
Add the Igniter to the Flamethrower
Screwdriver to finish
Load a Plasma Tank
=========Alternatively=============
Put the Welder, Rods, and Igniter on a table
Hold a screwdriver
Click and drag the table to yourself
Select "Flamethrower"
Load a Plasma Tank

You can also get one from a hacked Autolathe, minus the plasma tank.

It should also be noted that the fuel inside the plasma tank determines the properties of the shot flame. Mixes of plasma and other gases can create different results when using the flamethrower, namely in temperature.

Improvised Shotgun

Essentially a tube that aims shotgun shells.

Requires
1 x , 1 x , 1 x , 1 x ,

Collect all the materials (make Modular Receiver from a Protolathe, make Rifle Stock from 10 wooden planks)
Put them on a table
Have Screwdriver in hand, drag the table on you and commence crafting and you're done
(If you want improvised shells for it, use Technological Shells from the Protolathe)

Meteorshot Shell

A shotgun shell rigged with CMC technology, which launches a massive slug when fired.

Requires
1 x Tech Shell, 1x RCD Ammo, 1x Micro-Manipulator,

Collect all components and place on a table
Click and drag the table to your sprite
Hold a screwdriver
Select "Meteorshot Shell" and wait a few seconds

Pulse Slug Shell

A delicate device which can be loaded into a shotgun. The primer acts as a button which triggers the gain medium and fires a powerful energy blast. While the heat and power drain limit it to one use, it can still allow an operator to engage targets that ballistic ammunition would have difficulty with.

Requires
1 x Tech Shell, 1x Advanced Capacitor, 1x Ultra-High-Power Micro-Laser,

Collect all components and place on a table
Click and drag the table to your sprite
Hold a screwdriver
Select "Pulse Slug Shell" and wait a few seconds

Dragonsbreath Shell

A shotgun shell which fires a spread of incendiary pellets.

Requires
1 x Tech Shell, 5u Phosphorus,

Collect all components and place on a table
Click and drag the table to your sprite
Hold a screwdriver
Select "Dragonsbreath Shell" and wait a few seconds

Pneumatic Cannon

A unique gas-powered gun that can fire anything loaded into it.

Requires
2x pipe, 8x package wrapping, 4x metal sheets

Collect all components and place on a table, including the tools
Select Pneumatic Cannon and craft
Acquire a medium-large sized gas tank to power the cannon

Bola

A simple device fashioned from a cable and weights on the end, designed to entangle enemies by wrapping around their legs upon being thrown at them. The victim can remove them rather quickly, however.

Requires
1x , 6

Collect all components and place on a table, including the tools
Select Bola and craft

Baseball Bat

The baseball bat does moderate damage and knocks back mobs.

Requires
5x

Click on the wooden planks in your hand and select "baseball bat".

Singletank Bomb

Singletank bombs are, unlike TTV bombs, constructed from a singular tank. As a result, they tend towards less explosive power but make up for it by being very easy to create in comparison. Experiment with gas mixtures - see if you can try and make something that's as big as the bomb cap!

Requires
1x , 1x detonator of your choice, 1x

 Create an igniter assembly, usually this is a signaller, by screwdrivering the igniter and detonator and combining them by slapping them together.
 (If you're using a signaller, make sure to set it off the default frequency to reduce the risk of someone randomly signalling your bomb).
 Attach the assembly to the tank by hitting it on the tank.
 Weld a pressure hole into the tank with a welding tool.